See photographs. It is a molded, soft, rubber safety cap that firmly attaches to the very sharp top and edges of the steel I-Beam support behind a guardrail - and next to a sidewalk where pedestrians walk, run, or ride bicycles. For either a public or private venue, protection is necessary to prevent injury in case of someone tripping or falling against the very sharp steel top, and to mitigate against undue liability.

Application:  Anywhere there is a pedestrian sidewalk behind a guardrail.

Once again, an American Molded Plastic innovation provides increased safety, reduced liability, and low cost products that save budgets and departments with very efficient installation. Also see our line of proven  highway barrier delineators.

AMP Guardrail Safety Caps^TM Provide...

Just how easy and fast is the installation?
Install 1 - 2 - 3 ...

Three steps. Finish in far less than a minute - just a matter of seconds! Three photos directly below.

1. Apply adhesive to the grooved bottom of the safety cap
2. Fit grooved bottom onto the I-Beam
3. Press firmly onto the I-Beam. Done.

 If you are not working directly with a salesman on pricing,
please call us for assistance, additional specifications, etc. Thank you!

PRODUCT INFORMATION PDF                           INSTALLATION INSTRUCTIONS PDF

(PDFs download or open in a new window)

[Back to Page Top]